Ag-leader Yield Monitor 2000 Operators Manual User Manual download pdf (Page 101)

Yield Monitor 2000

Logging Map Data to a Card

Ag Leader Technology

June 1997

4-35

Memory Card

Requirements

The following characteristics are required of memory cards you intend to use

with the monitor:

• Type 1 or Type 2 PCMCIA (68-pin) SRAM memory cards

• Card sizes of .5 kilobytes and 1, 2, and 4 megabytes

• Memory cards with 200 nanosecond (ns) speed ratings are desired

• Some 250ns cards also work in the monitor. 250ns Epson and Mitsubishi

cards have been used successfully.

Note: 1 Meg memory cards are available through Ag Leader Technology.

IBM cards will not work in monitors with serial numbers below 941101, but

will work in monitors with higher serial numbers.

Setting Monitor to

Follow these steps to log to a memory card:

Log to Card

Step Action

1 Press the SETUP key until “LOGGING DEVICE = NONE or EXT

or ?M CARD” appears on the display.

2 Press the top UP or DOWN ARROW key to select “?M CARD”.

Note: When you turn the monitor on with it set to LOGGING

DEVICE=?M CARD, the message “INSERT CARD OR PRESS NO”

appears on the monitor. Either insert a card or press the NO key. If you

insert a memory card, refer to the instructions below to format and initialize

the card. The monitor also looks for a GPS signal when it is set to log to a

card. You will see two dashes in the top-right corner of the display where a

D and G will appear if you have a GPS signal.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 201 202

No comments

Ag-leader Yield Monitor 2000 Operators Manual User Manual Page 101