Ag-leader Yield Monitor 2000 Operators Manual User Manual download pdf (Page 27)

Yield Monitor 2000

Setting Initial Calibration

Ag Leader Technology

Numbers

June 1997

2-23

Setting Initial

Calibration

Numbers

Refer to the Yield Monitor Initial Calibration Sheet in this section to set the

calibration numbers for each grain type.

Follow these procedures to set the calibration numbers for each grain type:

Step Action

1 Press the GRAIN key and use the bottom-left UP or DOWN

ARROW keys to select a grain type that you will harvest.

Note: You must have a load displayed to change the grain type.

2 Press the GRAIN key until “M1=xxx” appears on the display.

3 Check the value shown for this grain type against that on the Initial

Calibration Sheet. If the value is not correct, use the bottom-left

UP or DOWN ARROW keys to set it.

4 Press the GRAIN key again to advance to the S1 value.

5 Check the value shown for this grain type against that on the Initial

Calibration Sheet. If this value is not correct, use the bottom-left

UP or DOWN ARROW keys to set it.

6 If grain weight (pounds) has never been calibrated for this grain

type, press the GRAIN key to advance to the C11 value.

7 Check the value shown for this grain type against that on the Initial

Calibration Sheet. If this value is not correct, use the bottom-left

UP or DOWN ARROW keys to set it.

Notes:

• You may not be able to set C11 to the exact number as on the

Initial Calibration Sheet. Set it as close to the initial number as

you can.

• When you change C11, the C2 through C10 values change

proportionally (they may not agree with the numbers on the

Initial Calibration Sheet, but they will be close enough).

• If pounds has been calibrated previously for this grain type, do

not change C11.

8 Press the GRAIN key until the grain type appears on the display.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 201 202

No comments

Ag-leader Yield Monitor 2000 Operators Manual User Manual Page 27