Ag-leader Yield Monitor 2000 Operators Manual User Manual download pdf (Page 20)

Settings Under SETUP Key

Yield Monitor 2000

Ag Leader Technology

June 1997

2-16

Tooth Sprocket Press the SETUP key until “x TOOTH SPROCKET” appears on the display,

then use the top UP or DOWN ARROW keys to set the number equal to the

Initial Calibration Sheet if needed. This number should have been set

correctly at the factory.

Note: This sprocket is at the top of the clean grain elevator and the elevator

paddles rotate around it.

TI, T2, and T3 Press the SETUP key three additional times until “T1=10,” “T2=5,” and

“T3=8” appear on the display, then check these numbers against the Initial

Calibration Sheet. If they are not set correctly, change them using the top UP

or DOWN ARROW keys. These numbers should have been set correctly at

the factory.

* * *

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 201 202

No comments

Ag-leader Yield Monitor 2000 Operators Manual User Manual Page 20