Ag-leader Yield Monitor 2000 Operators Manual User Manual download pdf (Page 178)

Troubleshooting

Yield Monitor 2000

Ag Leader Technology

June 1997

6-26

3. The cable used to connect the GPS receiver to the monitor is incorrect.

Solution: If a cable designed for the Yield Monitor 2000 was not

provided with your GPS receiver cable, obtain a GPS null modem cable

from Ag Leader Technology. Do not use a null modem cable from a

local store because it may be wired incorrectly and could damage the

monitor or reset the memory in the GPS receiver.

The GPS null modem cable switches pins two and three, sends pin five

straight through, and disconnects all other pins. It also changes the

connector gender

High Yield

Reading After

Stopping

The monitor displays a high yield reading when you have stopped the

combine with the separator engaged.

1. The C1 value (calibration number that eliminates false grain flow from

vibration) must be adjusted.

Solution: Refer to the Vibration document in the Calibration section.

Monitor Chirps

While Harvesting

1. The monitor is set on a partial swath (cut swath less than head swath).

Solution: Press the SWATH or # ROWS key and use the top UP

ARROW key to adjust the cut swath up to the head swath.

Card Too Small to

Log

The message “CARD TOO SMALL TO LOG!” appears after erasing and

formatting a .5, 1, 2 or 4 Meg card.

1. The card either has a bad battery or it has damaged memory.

Solution: If the monitor says the card has a good battery (the monitor

will tell you the status of the battery after you have erased and formatted

a card), the card has damaged memory and should not be used.

If the monitor says the card has a bad battery, replace the battery. If the

battery is rechargeable, put the card in the monitor with the monitor

turned on and let the card charge (you should be able to use the card

after 10 to 30 minutes of charging).

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 201 202

No comments

Ag-leader Yield Monitor 2000 Operators Manual User Manual Page 178