Ag-leader Yield Monitor 2000 Operators Manual User Manual download pdf (Page 25)

Yield Monitor 2000

Moisture Setting

Ag Leader Technology

June 1997

2-21

Setting/Changing

Moisture

The monitor can be set on automatic moisture to receive readings from the

moisture sensor or manual moisture to use an average moisture for each

load. The monitor comes from the factory set on automatic moisture.

Follow these steps to set the moisture setting.

Note: Any new loads you create will have the same moisture setting as that

of the last load in the same field. Make sure all of the existing loads are set

on automatic moisture.

Step Action

1 Press the LOAD key to display a load on the top line of the display.

2 Press the MOIST key until “MOIST=AUTO or MAN” appears on

the display.

3 Use the bottom-left UP or DOWN ARROW key to select AUTO or

MAN.

4 If you set MOIST=MAN, you must enter an average moisture value

for that load. Press the MOIST key until “xx.x AVG %” appears on

the display.

5 Use the bottom-left UP or DOWN ARROW keys to set an average

moisture value for that load.

Buildup on the

Sensor

The moisture sensor can give readings that are too high if sticky material

from weeds or green stems buildup on the moisture sensor. This is normally

only a problem in soybeans with a lot of weeds or green stems. If you have

high moisture readings from buildup, remove the moisture sensor and clean

it. After cleaning, continue harvesting. If the buildup condition is severe,

you may not be able to keep the moisture sensor clean. In such conditions,

set the moisture for the load on manual and enter the average moisture for

that load as instructed above. After buildup conditions cease, set the

moisture back to automatic.

* * *

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 201 202

No comments

Ag-leader Yield Monitor 2000 Operators Manual User Manual Page 25