Ag-leader Yield Monitor 2000 Operators Manual User Manual Page 123

  • Download
  • Add to my manuals
  • Print
  • Page
    / 202
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 122
Yield Monitor 2000
Printing Field/Load Summary
Ag Leader Technology
June 1997
4-57
Connecting the
Monitor to the PC
Follow these steps to connect the yield monitor to your computer:
(Windows 95)
Step Action
1 Remove the yield monitor from the combine and use the provided
12-Volt DC power supply to turn the monitor on next to your
computer.
2 With the monitor off, connect one end of the six-foot cable (two,
nine-pin connectors) provided with the monitor to the nine-pin port
on the bottom of the monitor.
Note: Monitors with serial numbers greater than 941000 have
voltages on the nine-pin serial port that should not be connected to
your computer. Therefore, use only the special nine-pin to nine-
pin cable (connects only pins 2, 3, and 5) provided by Ag Leader
Technology. Do not use a standard cable.
3 Find an unused COM port on the back of your computer. If they are
all in use, you must disconnect another device from one of the ports.
The COM port will have either 9 or 25 pins. If it is a nine-pin port,
connect the cable from the monitor directly to the port. If it is a 25-
pin port, use the adapter provided with the cable to connect to the
computer.
Follow these steps to set up HyperTerminal to accept data from the yield
monitor:
Step Action
1
Click on Start.
2
Click on Programs.
3
Click on Accessories.
4
Double-click on HyperTerminal.
5
Double click on the icon with hypertrm or hypertrm.exe under it.
A series of popups will appear on the PC display.
6 Enter a name in the “Connection Description” popup
(recommendation: YM2000). Choose an icon that will be
associated with the name you entered and then click the OK button.
7 Click on the down arrow at the bottom of the “Phone Number”
popup where it says “connect using” and choose the COM port to
which the monitor is connected. If you do not know the COM port,
begin with “Direct to COM1”, then click on OK.
Page view 122
1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 201 202

Comments to this Manuals

No comments