Ag-leader Yield Monitor 2000 Operators Manual User Manual download pdf (Page 170)

Troubleshooting

Yield Monitor 2000

Ag Leader Technology

June 1997

6-18

4. The ground speed and elevator speed extension cables have been

interchanged.

Solution: On the distribution cable (a cable eight inches long with six

separate connectors), look at the labels on the elevator speed and ground

speed cables and make sure each cable is plugged into the correct

connector on the distribution cable (elevator speed: two-pin female

connector, ground speed: two-pin male connector)

Incorrect Distance

and MPH

1. You have not calibrated for distance or the calibration is incorrect.

Solution: Follow the instructions in the Distance document in the

Calibration section if you have calibrated distance. Each speed

settingWHL, RAD, TRK, GPS/WHL, GPS/TRK or GPS/RAD

require a separate calibration.

Press the DIST key until “xxxx PLS/100”, the distance calibration

number, appears on the display. The number should be between 2500

and 4500 for most combine ground speed and radar sensors. If the

number is too high, such as 9000 to 10000, the monitor will not count

enough feet and acres, and mph will be too low. If the number is too

low, the monitor will count too many feet and acres, and mph will be too

high. Calibrate for distance again if you think the distance calibration

number is incorrect.

Note: You must calibrate the backup speed sensor for the GPS speed

setting you are set on.

After you calibrate for distance, the monitor automatically corrects any

incorrect distance and acres for previously harvested loads that were set

on the speed setting for which you calibrated.

2. You are not displaying the current data load (load with an arrow to the

right of the load number, for example, L1->) and therefore do not see

any distance accumulating while you drive (you will see mph).

Solution: Press the LOAD key to display the field and load on the top

line and use the top-right UP or DOWN ARROW key to find the data

load (you may have to change fields).

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 201 202

No comments

Ag-leader Yield Monitor 2000 Operators Manual User Manual Page 170