Ag-leader Yield Monitor 2000 Operators Manual User Manual download pdf (Page 40)

Calibrating Distance

Yield Monitor 2000

Ag Leader Technology

June 1997

3-4

Step Action

7 Use the lower-right UP or DOWN ARROW key to increase or

decrease the number of feet displayed so that it is equal to the

distance measured.

Notes:

• When you change the feet measurement on the display, you are

changing the distance calibration number. You can see the

number if you press the DIST key until “xxxxpls/100’ “ appears

on the display.

• It may take several increment or decrement cycles to go from

where the measured distance is 1 foot under to 1 foot over the

measured distance. Count the number of beeps and set it in the

middle of this range.

Clearing Feet Out

of the Load

Follow these procedures to clear the feet out of the load:

Step Action

1 Press the MEM key until “CLEAR DATA IN THIS LOAD?”

appears on the display.

2 Press the YES key.

3 After the Monitor beeps four times and “ARE YOU REALLY

SURE? YOU WILL LOSE DATA” appears on the display, press

the YES key again.

4 If you are using a GPS receiver for ground speed, change the

“SPD=” setting back to the correct GPS setting for that load.

Calibrating

Distance

Accurately

Turn the combine around and repeat the above steps for calibrating distance

and clearing feet out of the load until you are confident that you have set the

distance calibration as accurately as you can.

Note: Perform this check while traveling forward only because combine

tires roll slightly differently in forward than they do in reverse.

* * *

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 201 202

No comments

Ag-leader Yield Monitor 2000 Operators Manual User Manual Page 40